beautypg.com

With utilit- track system, Step 4: installing rails – Pace-Edwards BL Nissan Titan User Manual

Page 4

background image

STEP 4: INSTALLING RAILS

REMOVE PROTECTIVE PAPER ON
UNDERSIDE OF RAILS. THIS IS FOR
PACKAGING PURPOSES ONLY.

The machined end of the rail attaches to the
canister.

You will need to lift the hanging portion of the
ribbed blanket and thread it in the rail while sliding
the rail into the rail grip mounted to the ends of
the canister (the underside of the blanket ribs
need to nest on the gear
)
.

Make sure both fl anges of rail slide into the rail
grip.

Push the rails forward against the canister.

Complete for both left and right rails.

Remove the support or stand and lower the
canister and rail assembly onto the front sill and rails of the truck bed.

Slide the entire canister and rail assembly forward against the cab end of the truck bed.

Close the tailgate and pull the rails only toward it leaving approximately 1/8” gap between the end of the rails and
the tailgate.

Be sure to hold the canister in place to ensure it does not move from the front truck bed sill with the rails while
adjusting the gap of the rails to the tailgate.

Rail Grips

Rail
Flange

BEDLOCKER

®

NISSAN TITAN

4

Ribbed
Blanket

STEP 5: INSTALLING CLAMPS ON TRUCK WITH UTILI-TRACK

CHANNEL SYSTEM

HARDWARE USED:

(1) CLAMP RAIL GRIP x 4

(2) RAIL GRIP BLOCK x 4

(3) CLAMP SHIM x 4

(4) CLAMP SPACER x 4

(1) CLAMP RAIL GRIP

(2) RAIL GRIP BLOCK

(3) CLAMP SHIM

(4) CLAMP SPACER

(5, 6 & 7) CLAMP RAIL BOLT, LOCK &
FLAT WASHER

RAIL

TRUCK BED RAIL

UTILI-TRACK
CHANNEL SYSTEM

(8) ALLEN SCREWS

FIG. 5A

Before shimming and installing the rail clamps make sure the canister is centered between
the truck bed rails.

Take the Clamp Rail Grips (1) and slide 2 on each rail, 6-12” from the canister and 6-12”
from the tailgate.

With the tailgate closed, slide the rails to establish the correct spacing to the tailgate. The
rails have rubber spacers on the end caps, to establish the correct spacing (1/16”) and to
prevent the tailgate from striking the rails when closing. Make sure the canister stays snug
up against the cab end of the truck bed while establishing correct spacing to the tailgate.
Once the rails are correctly placed open the tailgate.

Install the Rail Grip Blocks (2) into the track system on the truck bed with the grip lines
running vertically (up and down). Position them behind the Clamp Rail Grips (1)

WITH

UTILIT-

TRACK

SYSTEM