beautypg.com

Gatco 6641-Latitude2 8" Widespread Faucet in Chrome User Manual

General installation instruction

background image

GENERAL INSTALLATION INSTRUCTION

Latitude2 Widespread faucet

E

D

F

G

A

B

C

PREPARATION

Tools Required for Assembly:

(Not included)

• Teflon tape

• Plumber’s putty

CAUTION:

Before removing old faucet, turn off the cold and hot water supply lines and open the

old faucet to release pressure build-up.

CAUTION:

When installing new faucet, tighten connector nuts first by hand, then use a

wrench to tighten the fitting.

CAUTION:

Use Teflon tape on all threaded connections.

INSTALLATION

INSTRUCTION

• Philips head screwdriver

• Pliers

Shut off water supply lines and remove old faucet.

Remove the tee connector, and spout mounting hardware from spout. Place spout

through center mounting hole in counter top / sink.

From beneath the counter top/sink, secure the spout with rubber washer (A), metal

washer (B) & locking nut (C). The openings of the washers should be facing back

where pop-up drawin pull will be inserted.

To properly lock spout in place hand tighten locking nut (C) till snug then align the

spout and use a plier to lock nut in position.

Wrap the spout shank with Teflon/ Plumbers tape. Then place the tee connector

washer (D) and cone washer (E) tapered side up inside the sealing nut (F). Insert tee

connector (G) onto the end of the spout shank. Tighten sealing nut (F) to seal.

In most cases the sealing nut will be already attached to the tee connector and

should just be tightened to ensure no leaks.

1