Gatco 1563-Bleu Minimalist Mirror in Chrome - Manual

• Philips head screwdriver
• Tape measure
• Level
• Safety glasses
10. Align the two upper mirror
brackets (C) with their
respective mounting brackets
(A). Carefully push them over
the pins. (Fig. 7)
5. Unscrew the screws (b)
from the Molly bolts (B).
Molly bolts will remain in the
wall. (Fig. 3)
Caution: Two people are required to safely install this oval mirror. The mirror will break if dropped. Take extra precautionary
measures to ensure a secure grip on the parts.
Caution: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (not included)
INSTALLATION INSTRUCTION
B
Fig. 2 Side View
9. Rest the mirror (F) on the
lower mirror brackets (C), and
place the two upper brackets
on the top edge of the mirror.
(Fig. 6 and 7)
1. Once the location of the
mirror has been determined,
mark the positioning of the
four mounting brackets (A)
and their screw holes with a
pencil. Use a measuring tape
and a level for accuracy.
(Fig. 1)
2. Drill 5/16 in. pilot holes
into the wall where the Molly
bolts will be inserted using an
electrical drill.
4. Use an electrical
screwdriver to tighten the
screws. This will collapse the
Molly bolts (B) tightly to the
wall. (Fig. 2)
8. Tighten their set screw (D)
with Allen wrench (E). Make
sure that the opening of the
groove is facing up. (Fig. 5)
PREPARATION
Tools Required for Assembly: (not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
6. Place the mounting bracket (A) over the Molly bolts (B). Insert
the screws (b) back through the bracket and the Molly bolts, and
then tighten firmly with Philips head screwdriver.
7. Secure the two lower mirror
brackets (C) to the wall by
placing them over the
mounting brackets. (Fig. 4)
3. Tap Molly bolts (B) into the pilot holes using a hammer.
11. Tighten their set screw (D)
with Allen wrench (F). Make
sure the opening of the groove is
facing down (C). (Fig. 8)
12. Tighten the set screws (G)
in each of the four mirror
brackets with Philips head
screwdriver. Tighten until just
snug – do not over tighten.
(Fig. 9)
• Hammer
Side View
f
Fig. 3
b
B
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
GENERAL INSTALLATION INSTRUCTION
BLEU DECORATOR MIRROR
A
C
Side View
Fig. 8
D
F
C
A
C
Fig. 4
Fig. 5
E
D
Side View
Fig. 9
G
F
C
Fig. 6
Fig. 7
Fig. 1 Front View
A