Gatco 1424-Premier Mirror in Chrome - Manual

PREPARATION
Tools Required for Assembly: (Not included)
• Electrical drill with 5/16 in. drill bit
• Mallet hammer
CAUTION: Drywall anchors are for drywalls only. Use tile anchors for tile surfaces. (included)
INSTALLATION INSTRUCTIONS
1. Hold the wall mirror (A) up against desired position on wall, and
mark the position of screw holes. (B) Remove the item. (Fig. 1)
2. Drill 5/16 in. pilot holes into the wall where the drywall anchors (C)
will be inserted.
4. Pinch drywall anchors (C) two wings together (Fig. 2), and insert it into the
hole horizontally. Tap flush with the wall using a mallet hammer.
5. Insert the red push pin (D) into the drywall anchors (C)
until the wings pop open. (Fig. 3) Then remove the pin.
Do not tap the red push pin with a hammer.
6. Place the wall mirror (A) over the drywall anchors (D).
Insert mounting screws (E) through the bracket and anchors,
and then tighten firmly with Phillips head screwdriver. (Fig. 4)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.
• Phillips head screwdriver
• Safety glasses
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Side View
a. b. c.
a. b.
GENERAL INSTALLATION INSTRUCTIONS
Wall Mirror | 1424, 1430 (Drywall installation)
Top View
Push
E
D
C
C
D
A
B