Gatco 1551-Latitude2 Magazine Rack in Chrome - Manual

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Mallet Hammer
CAUTION: Molly bolts are for dry walls only.
Use tile anchors for tile surfaces. (Not included)
INSTALLATION INSTRUCTIONS
1. Hold assembled item up against desired position on wall, and outline the back
plates of end pieces with a pencil. Use a measuring tape and a level for accuracy (Fig. 1).
2. Position a mounting bracket in the center of outlined back plate.
Use a pencil to mark positioning of the screw holes (Fig. 2).
3. Drill 5/16 in. pilot holes into the wall where the molly bolts will be inserted using an
electrical drill. Tap molly bolts into the pilot holes using a hammer (A).
Use an electrical screwdriver to tighten the screws.
This will collapse the molly bolts tightly to the wall (B). Unscrew the screws
from the molly bolts (C). Molly bolts will remain in the wall (Fig. 3).
4. Place the mounting bracket over the molly bolts. Insert the screws back
through the bracket and the molly bolts, then tighten firmly
with Philips head screwdriver (Fig. 4).
5. Secure the end piece with Allen wrench and set screw (Fig. 5).
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.
• Philips head screwdriver
• Tape measure
• Level
• Safety glasses
GENERAL INSTALLATION INSTRUCTION
Magazine Rack
Fig. 1
Fig. 2
Front View
A B C
Fig. 3
Fig. 4
Fig. 5