American Car Craft Corvette Stingray Mud Guards 4Pc Polished with Carbon Fiber Backing 2014+ C7 - Manual (Page 4)

to enter through the small slit provided in the new guard. It is also important that you
spread the factory clips legs for this shield as well.
10. With both the stainless mud guard and factory stone shield attach to the wheel well
pull back the top of the stainless mud guard and shield back enough to expose the clip
tabs. Then slide on and install the two top metal shield clips. Make sure that they are
seated all the way down on the tab and that the clip effectively secures the shield to the
guard. Making sure that you have spread the clips legs a little simply press and snap the
top end of the shield to the wheel well. Perform the same procedure for the lower
corner using the replacement clip provided with your kit. (Tech tip) Since the plastic tabs
securing the attachment clips is very soft it will be very easy for you to miss this last
whole preventing it to install properly. Look very closely at this so as to make sure it is
properly seated to finish the installation.
*Perform the same exact procedure for the driver side.
If any questions or problems occur during installation, please contact American Car Craft
at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com