American Car Craft Dodge Viper Glove Box Cover with Laser Etched Viper Head Logo Polished 1996-2002 - Manual (Page 2)

NOTE: Some glove boxes have been treated at the dealerships before you
purchased the car. So to be extra safe you may what to use the wax and
silicone remover just in case.
2. Once this is done use the adhesive promoter (provided in the little
plastic packet) to wipe your glove box’s entire area to be covered with
your new glove box cover. Allow 30 seconds to dry.
3. Before you remove the red liner for permanent attachment place the
Glove Box cover into position and check the fit. Your cover comes to you
pre-formed but it may be necessary to form (bend very slightly) by hand to
insure a nice flat fit without forcing. Make note of its position.
4. Remove the red liner from the taped back and carefully reposition the
glove box cover, be sure it is straight. Then press firmly on the cover
to set.
5. Let set for 2 hours and then remove protective clear top liner.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com