American Car Craft Corvette Stingray Fuel Rail Covers Factory Overlay Polished_Brushed Trim 2Pc 2014+ C7 - Manual (Page 2)

been achieved swipe the entire surface to be mounted with the adhesive promoter you will receive with any
of our stainless steel kits. This promoter is not a cleaner but an adhesive accelerator when used on a nice
clean and well prepared surface this chemical will create a very reliable bondable surface.
2. Now that all preparations have been made the next step will be to apply the accessory. It comes
with a little brushed trim ring that’s goes around the word corvette. You will need to place this on first. This
will help with positioning the main fuel rail piece so that it is in the exact spot it needs to be mounted in. You
can peel the red release liner from the back of the part. Keep in mind that the adhesive is very aggressive and
it will not allow you to reposition it once it has made contact with the surface. So go slow and sure. Once all
hole and the perimeters are lined up, set the part in place pressing firmly along the entire surface to bond the
part and then remove the protective liner. The bond will become permanent after twenty-four hours.
If any questions or problems occur during installation, please contact American Car Craft
at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com