American Car Craft Corvette Stingray Fuel Rail Covers Factory Overlay Polished_Brushed Trim 2Pc 2014+ C7 User Manual
American car craft instructions

AMERICAN CAR CRAFT INSTRUCTIONS
C7 CORVETTE STINGRAY – FUEL RAIL COVERS FACTORY OVERLAYS POLISHED
W/BRUSHED TRIM
PART #053003
PARTS INCLUDED:
2-Polished Fuel Rails
2-Brushed Trim Rings
2-Adhisive Promoter Packets
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation. This liner is
required to remain on the part until you are instructed to remove it.
1. The first thing that needs to be done in any peel and stick application is surface preparation. It is
important that you examine the surface to determine if any kind of special treatments have ever been used.
Such as wax/silicone treatments and/or polymer surface preps. Take a strip of masking tape and press it very
firmly to make it adhere to the surface. Then peel it off to see how difficult it is to remove. If your masking
tape is removed extremely easy and/or does not stick at all then you will need to perform a special surface
preparation. In most cases like this you will need to make a solution of a straight detergent (Johnson’s Baby
Shampoo or Palmolive Dish Soap) and water. Mix a 32oz bottle with about five table spoons of soap
detergent. Once you have the solution made wash the surface scrubbing quite vigorously to remove any
surface contaminates.
When this is done you can proceed to the regular preparation. This is done by scrubbing the surface with
alcohol and wiping it dry. At this point you will need to test the surface again to see if you have achieved a
tack. Apply a new strip of masking tape to the surface. If it adheres you have done a good job, if it doesn’t then
you must perform the wash again and again if necessary until you have achieved a nice tack. Once a tack has