American Car Craft Corvette Wiper Cowl Cover Perforated 2Pc Polished 2008-2013 C6+GS - Manual (Page 2)

3. You have been supplied with an adhesive promoter snaps stick. Squeeze this
small tube until the vile inside breaks releasing the fluid onto the fiber end and
then apply a single bead along the front edge of the two pieces closest to the
engine. You have been provided with a long length of chrome trim. Cut one end
of the trim to match the angle at either end of the stainless inserts and then peel a
small length of the red release liner from the back of the trim and set the end you
just cut. Pull the red liner as you set the trim along the entire length of the
stainless until you reach the corner. Trim the end of the trim to match the shape of
the end point. Reinstall the factory rubber hood gasket.
If you have any questions during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com