American Car Craft Corvette Wiper Cowl Cover Perforated 2Pc Polished 2008-2013 C6+GS - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
2008-2013 C6 CORVETTE PERFORATED WIPER COWL INSERT
PART #043058
PARTS INCLUDED:
1-2pc Stainless Wiper Cowl
1-Adhesive Promoter Pack
1-Adhesive Promoter Tube
1-Length of ¼” Chrome Molding 60”
Your new cover comes to you with a protective liner. Remove liner as instructed
below.
1. Remove the factory hood gasket from the wiper cowl by simply pulling forward
and off. Then thoroughly scrub clean the cowl area jus behind the gasket ridge.
Once this is complete swipe the entire area with the adhesive promoter provided.
2. Before you permanently attach any thing place the two long strips of stainless into
position to get acquainted with the fit and to see for yourself just how you will go
about setting each of them in place. The two pieces should butt tight to each other
with no gap. Once you are satisfied with the fit remove the red release liner from
the back of the parts and then carefully set them back into position and press
firmly along its length to set the parts to the factory plastic. Once this is done
remove the protective liner.