American Car Craft Corvette Water Tank Cover Perforated w_caps - 2005-2013 C6+Z06+GS Manual Trans. only - Manual (Page 3)

scissor. You will also need to trim the finger tab from this cap in the same way.
Once this is done simply snap the cap onto the fill neck.
6. Replace the factory water tank cap and scrub the tops of both factory caps with
household rubbing alcohol to remove any dirt and grime then swipe the two
caps with the adhesive promoter provided.
7. You have been provided with two decorative chrome caps. You will notice that
these caps will contain Velcro attachment cookies inside them. Remove the
cookies halves and install them on top of the two factory fluid caps you just
prepared.
8. At this time remove the clear protective liner.
9. Install the two corresponding caps and the top water hose. Be sure that the
factory hose clamp ears face downward as best as possible. Then slide the
notched chrome hose cover over the clamp to finish the installation.