American Car Craft Corvette Water Tank Cover Perforated w_caps - 2005-2013 C6+Z06+GS Manual Trans. only - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 CORVETTE WATER TANK COVER
W/ CAPS FOR MANUAL TRANS. - PERFORATED
PART#043100 patent pending
PARTS INCLUDED:
1-Stainless Water Tank Cover
1-Decorative Hose Collar
1-Adhesive Promoter
2-Decorative Chrome Caps w/Velcro Cookies for #C634 (2-3/4”)
3-Decorative Chrome Caps w/Velcro Cookies for #C634-1 (2-3/4”, 1-Full w/notch)
Your new accessory comes to you with a clear protective liner. This liner will help to
keep your new parts clean during installation. You will be instructed when to remove
the liner during the detailed installation.
YOUR NEW COVER HAS BEEN DESIGNED TO DRAMATICALLY ENHANCE THE LOOK OF THE
FACTORY OVERFLOW TANK AND WILL ADD A REALLY NICE CUSTOM LOOK TO YOUR
ENGINE BAY.
1. Using a pair of vice grips clamp the top flow hose so that when you remove it, it
will not leak any fluid. Using a regular plier’s squeeze the hose clamp to remove
the hose. Hold the hose straight up and lower the vise grip down some. Use a
paper towel to soak out the fluid in the hose. Remove the hose clamp.
2. Slide the decorative hose collar over the hose so that the large opening of the
collar faces towards the tank. Slide it down the tube enough to allow you to re-
install the hose clamp.
3. Remove the factory water tank cap and the windshield washer fluid cap. You will
notice that the water tank has a plastic overflow tube set into a hole retainer