American Car Craft Camaro Factory Shroud Trim Polished Plenum Kit 8Pc 2010-2013 - Manual (Page 2)

area with the adhesive promoter packet provided. NOTE: This packet is an adhesive
accelerator and NOT a cleaner. Do not use to clean the surface!
3. Each of the new stainless strips come to you pre shaped and are identical to each
other so it will not matter which one you put where however it is absolutely imperative
that each of the strips be carefully and accurately shape to sit onto the factory plenum
without forcing any part of it to sit flush. This means that although each of the strips is
pre shaped you will need to further shape them to sit perfectly before you remove the
red liner and stick them in place.
4. Once you have nicely matched each strip simply peel the red release liner from the
back of the strips and then carefully and accurately set them into place. Use a soft cloth
to firmly press each of the strips to the engine cover and allow setting overnight.
IMPORTANT: The bond of the attachment tape will accelerate and be complete after
about 24 HRS. This is important because the factory cover expands and contracts quite
considerable with the engine heat and in order for these stainless strips to hold fast the
bond will need to be thoroughly complete. Remove the protective liner to finish the
installation.
If you have any questions during installation please call American Car Craft
at 727 861-1500.
Thank you and enjoy your purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com