American Car Craft Corvette Hood Vent Grilles Laser Mesh Blakk Stealth 2006-2013 Z06+GS+ZR1 - Manual (Page 2)

3. Once preparations have been properly made place your new grille into the
opening to familiarize yourself with its position. Make sure that the new grille sits
high enough so that the black factory bezel will cover around it. Once you have a
good idea of how it is placed simply peel the release liner from the back of the
stainless grille and press firmly into position.
4. With the stainless grille installed prepare the hood opening for the black factory
bezel by cleaning off any remaining old attachment tape and then swiping it once
with the adhesive promoter provided. Once this is done remove the red release
liner from your new attachment tape on your factory bezel then snap the factory
bezel back into place pressing firmly to set the tape.
DO NOT GET WET FOR 24 HOURS!
If any questions or problems occur during installation, please contact American
Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com