American Car Craft Corvette Wiper Cowl Cover Polished 3Pc 2005-2007 C6 User Manual
Page 2
3. You have been supplied with an adhesive promoter snap stick. Squeeze this small
tube until the vile inside breaks releasing the fluid onto the fiber end and then
apply a single bead along the edge of the two pieces closest to the wipers. You
have been provided with a long length of chrome trim. Cut one end of the trim to
match the angle at either end of the stainless inserts and then peel a small length
of the red release liner from the back of the trim and set the end you just cut. Pull
the red liner as you set the trim along the entire length of the stainless until you
reach the corner. Cut the trim a little over the edge. Apply the remaining trim to
the small edge and allow the trim to completely overlap each other. Using a nice
new straight razor blade cut the cross section of the two overlapping pieces of
trim into a nice miter cut. Remove the excess top piece and then pull the bottom
piece so that you will expose the miter enough to allow you to place a tiny drop of
instant adhesive to the miter cut and then set the miter down into a nice joint.
Trim the remaining end of the trim at the edge of the stainless. Reinstall the
factory rubber hood gasket.
4. Peel the red release liner from the back of the remaining slotted section and then
simply press it in place and remove protective liner to finish the installation.
If any questions or problems occur during installation, please contact American Car
Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520