beautypg.com

American Car Craft Corvette Wiper Cowl Cover Polished 3Pc 2005-2007 C6 User Manual

American Car Craft For the car

background image

AMERICAN CAR CRAFT INSTRUCTIONS

C6 CORVETTE STAINLESS STEEL WIPER COWL INSERT (fits 2005-2007)

PART#043015


Your new cover comes to you with a protective liner. Remove liner as instructed
below.

PARTS INCLUDED:
1-3pc Stainless Wiper Cowl
1-Adhesive Promoter Pack
1-Adhesive Promoter Tube
1-Length of ¼” Chrome Molding 60”

1. Remove the factory hood gasket from the wiper cowl by simply pulling it straight

up and off. Then thoroughly scrub clean the cowl area just behind the gasket
ridge. Once this is complete swipe the entire area with the adhesive promoter
provided.


2. Before you permanently attach anything place the two long strips of stainless into

position to get acquainted with the fit and to see for yourself just how you will go
about setting each of them in place. The two pieces should but tight to each other
with no gap. Once you are satisfied with the fit remove the red release liner from
the back of the parts and then carefully set them back into position and press
firmly along its length to set the parts to the factory plastic. Once this is done
remove the protective liner.