American Car Craft Corvette Inner Fender Covers w_Chrome Cap Covers Polished 1997-2004 C5 & Z06 - Manual (Page 2)

3. Follow steps 1 and 2 for passenger side fender cover.
4. Snap on the four screw cap covers (provided) over the 4 screws for a
beautiful finish.
5. You have been provided with three chrome caps and a stainless ring. You
have also been provided with a round Velcro cookie and 2 ½ round Velcro
cookies. Use these cookies to achieve the proper angle and height. Once you
have installed your covers you will need to clean the tops of your factory
fluid caps. Do this by scrubbing first with household isopropyl alcohol and
then wipe each cap once with the adhesive promoter (provided). Using a
scissor or snap knife, trim off the large hinge and finger tabs of the washer
fluid cap, attach the Velcro attachment cookie until the cap appears flush
with your new fender cover. Use one or two of the Velcro spacers (provided)
if needed to achieve a nice level cap. The stainless ring is designed to go
around the factory radiator fill cap first then attach your chrome cap cover.
Then you can finally attach the brake fluid. To help stabilize the drivers
side cover in position place one or two of the felt spacers (provided) between
your new cover and the top of the brake fluid container. By doing this you
will also be able to level out your new fender covers.
6. You have been provided with six chrome strips of varying sizes. These strips
are supplied to you should you decide to further enhance the look of your
new fender covers. Look at the pictures provided to see which one goes
where and to further decide if you would prefer this retro look or not. If you
decide to use them simply peel the release liner and stick in place being sure
to set them nice and straight and press firmly to set them.
TECH TIP: If you are installing our deluxe fender covers you may want to clear any
obstructions that may be present between the frame of the vehicle and the fender
covers such as the wire harness a/c lines or the water hoses. Although it is generally
not necessary to do this it will create a much nicer cleaner end result. It is possible to
reroute the passenger side water tank upper hose by detaching it and routing it
under the tank. Be sure that you have created adequate clearances to protect any
hoses or lines from rubbing or cutting.