American Car Craft Corvette Inner Fender Covers w_Chrome Cap Covers Polished 1997-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
CORVETTE C-5 INNER FENDER COVERS
PART # 033019
patent pending
Parts included:
___ 2- Stainless Fender Covers
___ 3-3/4 Chrome Cap Covers w/ Velcro Attachment Cookies
___ 1- Stainless Ring
___ 4- 1” Pan Head Screws
___ 4- Flat Nuts
___ 4- Snap on Screw Covers w/Sockets-small
___ 2- Felt Spacers
___ 1- Velcro Adjustment Cookie Spacer
___ 2- 1/2 Velcro Adjustment Cookie Spacers
___ 1- Adhesive Promoter
___ 6-Chrome Accent Strips
Your new covers come to you with a protective liner. Do not remove this liner until
installation is complete.
1. Place the larger driver sides cover into place front side first under the
headlight motor. You will need to tuck the motor harness out of sight
between the motor and the factory fender well. Align over water tank and
brake fluid cap. Be sure the cover fits properly. (Note: It may be necessary
to slightly curve the front of your new cover so that it fits flush without
forcing.)
2. You will notice that there are two pre-drilled holes in the covers trim
molding. Pre-drill through these two holes using a 9/64-drill bit. Using the
screws (provided) place two of them thru the small white cap sockets
(provided) then screw your new cover in place at the same time holding 1 of
the 4 flat nuts (provided) under the fender well. THIS FLAT NUT MUST
BE USED TO PREVENT SCREW FROM STRIPPING THE
FIBERGLASS FENDER WELL.