American Car Craft Corvette Side Vent Grilles Laser Mesh 6Pc 2010-2012 Grand Sport only User Manual
Page 2
3. Each of the grand sport fender vent grills that will come to you are formed however it is essential that you further the
shape and form to match the opening exactly in order to achieve the best end look and long term bond. Each of the grills
has been designed to allow you to do this using your fingers or if you prefer a common plier to adjust each of the tapes
so that they conform to the fenders inner contours. Once you have achieved a nice contour and shape with no gaps
simply peel the red release liner from the grills attachment tape and then carefully set them into position pressing firmly
against the outside as well as the inside to achieve a nice complete bond. Once you have set the grill simply follow a
reverse procedure to reassemble the wheel well and mudguard as well as the fender.
It is important to know the each of the grand sport grills will come to you looking like the top area is unfinished and
may even appear defective. This is the design of the grill and will look just fine once it has been properly installed.
You have been supplied with two lengths of chrome trim (Optional) This trim has been supplied to be placed at the
outer edge of the vent opening to add a nice finished appearance. Simply clean the vent ridge with household rubbing
alcohol then swipe with the adhesive promoter provided. Once preparation is complete simply peel the red release
liner from the precut trim and set in place. Press firmly to set.
If you have any questions during installation, please call American Car Craft at 727.861.1500.
Thank you and enjoy your purchase!
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520