beautypg.com

American Car Craft Corvette Side Vent Grilles Laser Mesh 6Pc 2010-2012 Grand Sport only User Manual

American car craft instructions

background image

AMERICAN CAR CRAFT INSTRUCTIONS

GRAND SPORT LASER MESH 6PC SIDE VENT GRILLES

PART #042082

PARTS INCLUDED:
6x Stainless Grills
2xAdhesive Promoter Packs
2x Chrome Vinyl Strips Molding (optional)

1. Remove the retainers securing the Z06 style mud guard from the fender. You can do this by pulling the center nail out
from the black plastic base of the retainer releasing it from the inner wheel well. Then pull the mud guard free from the
fender this part of the mud guard is snapped in and need only be pulled to unsnap it. There is a small plastic hook at the
top so after it is unsnapped simply pull it downward to release it. There is also on retainer attached to the underside of
the fender area you will need to release this one as well.

2. Now that the mud guard has been removed you will notice two 9/32 body screws just under the fender. Remove
these two screws and this will release the entire fender from the car allowing you to reach in and release the inner
fender vent shield. This shield is just a simple plastic cover stuck to the inner fender wall and can simply be separated by
hand, allowing you full access to the inner side of the fender vent openings. With the newly acquired access you can
now thoroughly scrub clean the inner fender with alcohol to remove any road grime and dirt. Then swipe this area with
the adhesive promoter provided. PLEASE NOTE: This chemical is not a cleaner but a very vital component that will insure
that these peel and stick application will hold long term and must be used.