American Car Craft Corvette Fuel Rail Covers Replacement Style w_Cap Cover 1999-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C5 REPLACEMENT FUEL RAIL COVERS
PART #033048
Parts Included
2x Fuel Rail Covers
2x Velcro Brackets
1x Steel Fuel Line Cap
Introduction: These new covers are a unique and easy to install design that will allow more ventilation for
your higher power, hotter running performance engines. The new covers offer beautiful restyling to your engine
bay and are made of the finest stainless material available, truly a high end custom accessory.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. Remove your factory fuel rail covers by simply pulling them off the engine. Both covers simply snap in
place.
2. Detach the fuel line, please note you will need a simple fuel line removal tool available at any auto part store.
3. You have been supplied with two fuel rail brackets that contain Velcro Attachment Tape. These two brackets
come to you flat but are designed so that you can manually form them so that you will be able to set them over
your factory fuel rail and then down to the rail mounting bolts. Once you have shaped them accordingly remove
the two factory bolts for each fuel rail then place the bracket over the hole locations. Then reinstall the bolts
securing the bracket so that the Velcro set over the rail itself. Once they are bolted in place tweak the shape so
that they sit nice and flat over the top of the two rails.
4. Your new covers come to you preformed however it may be necessary to further tweak the shape so that you
will be able to take them on and off perfectly also so that you will be able to set them nice and flat to the fuel