American Car Craft Corvette Tribal Skulls w_Blackout Kit 8Pc 2005-2013 C6 all - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 CORVETTE STAINLESS TRIBAL SKULL TAILLIGHT COVERS
PART# 042073
patent pending
PARTS INCLUDED:
___ 4-Stainless Taillight Covers
___ 2-Tubes of Adhesive Promoter
___ 5- ¼” Pre-cut molding strip
VERY IMPORTANT!! PLEASE READ ENTIRE INSTRUCTIONS BEFORE
BEGINNING THIS INSTALLATION!!
1. Clean each of the taillight openings first with rubbing alcohol to remove any
dirt and wax. Then swipe the painted area closest to the lens with one of the
adhesive promoter packs provided.
2. You have been supplied with four lengths of molding. Starting at the left or
right side of the lens tab at the top of each light place this molding directly to
the painted surface, as you pull the release liner from the back of the
molding, working your way around to the opposite side pressing firmly to
set. Trim away any excess molding. PLEASE NOTE: Make sure that the
molding attaches to the painted surface and that it rest against the taillight
lens. This strip of molding creates a bondable surface for the new covers to
attach to.
3. Now that all four taillights have been fitted with the attachable molding,
swipe all four molding strips with the second pack of adhesive promoter
provided. Carefully (DO NOT SCRATCH YOUR PAINT!! you may elect to
put some masking tape on your painted surface area) set each taillight cover
in place and check the overall shape. Although the new covers come to you
preformed it will be necessary to hand form each cover so that it matches the
placement of the molding at both sides ONLY without forcing it. It should
lay flat to the left and right sides of your molding attachment strip only NOT
TO THE TOP OR BOTTOM. This can easily be done by gently shaping each
cover with both hands horizontally until the desired shape is accomplished.