American Car Craft Camaro Shock Tower Dome Kit Polished Stand Alone 3Pc 2011-2013 - Manual (Page 2)

2. You will notice the large wire harness attached between the passenger side shock tower and fender. Detach this
harness by pulling it up releasing the two snap in retainers and then snip these two retainers off the harness.
This will allow the harness to tuck further under the fender ridge creating clearance for the new dome and
moving it out of visual range. You will also notice a relatively large tab casted off the harness tray. This tab is a
redundant extrusion and will need to be trimmed off the tray completely. Simply slice the plastic tab along the
apparent edge until you have trimmed it off completely. This should take just a few minutes.
3. Now you can set each of the two domes in place to get acquainted with their intended positions. Tweak the
covers so that they contour to the oddly shape shock towers and also take a look at the two or three contact
points under each cover and mark those spots with a marker. These will become the attachment points for the
two new covers.
4. Lift off the new covers and then install two or three of the Velcro attachment cookies furry side to the towers
and hook side to the dome. Depending on how well you shape the new covers you may need to stack a couple
of Velcro cookie’s together to make an attachment spacer. Try to get the domes to fit nice and close to the
towers. This will eliminate any possibility of the hood coming in contact with the domes as this can possibly ding
or dent the domes. A properly placed dome will have adequate clearance if all these aspects are kept in mind
during the installation.
5. With the Velcro attachment cookies in place simply peel the protective liner from each of the covers and then
simply place them over the towers for a nice snug fit. Then re attach the factory hood prop to finish the
installation.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520
www.americancarcraft.com