American Car Craft Camaro Shock Tower Dome Kit Polished Stand Alone 3Pc 2011-2013 User Manual
American car craft instructions

AMERICAN CAR CRAFT INSTRUCTIONS
CAMARO SHOCK TOWER DOMES 3pc 2013
PART #103061
PARTS INCLUDED:
2-Chrome Domes
1-Stainless Shell
10-Velcro Cookies
1-Adhesive Promoter Pack
Introduction: These new dome covers are a great way to cover and customize the top of the Camaro shock towers
should you elect to not use the factory strut support provided for on the new towers. The new dome is designed to cap
off the exposed and unsightly threaded whole platform.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
1. The first step will be to remove the factor hood support strut and set it up in such a way as to still support the
hood so you can work under the hood but without the strut in your way. Positioning it at the nose area will work
best. Then remove the strut stud. NOTE: It is important to know the strut stud removes from the right side of
the bracket and the nut on the left side of the bracket is permanently welded and cannot be removed. Once the
stud has been removed place the stainless shells provided in your kit over the stud hole and then replace the
stud and snug it down. This shell is provided to finish the opening in the main dome hole.