American Car Craft Corvette Door Knee Guard 2Pc Set Brushed 2005-2013 C6 - Manual (Page 3)

5. Before you remove the red liner for permanent attachment place the knee
guard plate into position and check the fit. Your plate come to you
preformed however it will be necessary to form by hand to insure a
nice perfectly contoured fit. When you are holding the plate up to the
door it should lay flat and conform to the shape of the door without
forcing it. (In other words it should look like it is installed and not be
protruding from the door panel in any way). Please refer to the pictures at
the end of these instructions. Make note of its position. NOTE: Be sure that
your trim plate lays flat to your door with no gaps between it and your
door.
6. Remove the red liner (be sure not to touch the adhesive) and carefully
reposition the knee guard plate, press firmly on the plate to set.
If any questions occur during installation please contact American Car
Craft @ 727 861-1500.
Thank you and enjoy your purchase!
Note: Care must be taken when cleaning your knee guard trim. It is a
good idea to lightly dust your trim plate with a clean soft cloth first in order
to prevent any particles from scratching it. Then wipe (using a new clean
soft cloth) with a good quality streak free glass cleaner.
This is how your installed knee guard is designed to fit
on your door panel.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com