American Car Craft Corvette Door Knee Guard 2Pc Set Brushed 2005-2013 C6 - Manual (Page 2)

1. BEFORE YOU BEGIN YOU MUST FIRST PREP THE DOOR PANEL IN
ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the
entire area first with household isopropyl alcohol. Then closely follow the
procedures outlined in the following steps!!!!
2.
If your door panels have been treated with armor-all or silicone
coatings, installation will NOT work unless these treatments have
been REMOVED with special chemicals! Household Isopropyl
alcohol alone WILL NOT remove it.
NOTE: Some doors have
been treated at the dealerships and the factory
before you purchased the car
. So to be extra
safe we suggest that you please refer to
the SPECIAL PREPARATION
INSTRUCTIONS enclosed. We can not be
responsible for plates not sticking due to
improper door preparation!
3. NOTE: YOU HAVE BEEN PROVIDED WITH A SMALL ABRASIVE PAD
AND 1 TEST STRIP.
4. Lightly scuff the area to be mounted with the abrasive pad provided and
wipe off any and all shavings. This step will produce a raw surface. Once
this is done swipe the entire area with the adhesive promoter
(provided). Allow a few seconds to dry. Use the test strip provided to test
tackiness of the door knee guard area to be mounted. If all the procedures
from the SPECIAL PREPARATION INSTRUCTIONS have been
preformed properly your test strip will stick. If it does not stick perform the
entire preparation again until it does.
DON’T ATTEMPT TO INSTALL
YOUR KNEE GUARD TRIM UNTIL YOUR TEST STRIP ADHERES
PROPERLY.
Installation errors are NOT manufacturing
defects and parts
CANNOT be returned
due to improper installation.