American Car Craft Corvette Side Graphic Sport Fade - Black Flame 2005-2013 C6 all - Manual (Page 2)

4. Your C6 Sport Graphic has been precut to fit into position perfectly and will
require only minor trimming. For this application we are going to use the
body of the car as a springboard to flip the graphic panel into position. First
you must clean the non-adhesive side of your graphic by misting your water
solution onto your cloth or paper towel then wiping the graphic free of any
dirt or dust particles.
5. Spray and saturate the entire side of your car with your soap and water
solution. NOTE: You will know if you have an adequate solution by looking
to see if the solution sheets and does not bead. If beading occurs add another
drop of soap to your solution and spray again.
6. Once the entire car is saturated place the clean graphic print side to the car
and paper side facing you so that the car and water hold the graphic above
your placement area and quickly remove the paper liner from one side to the
other as you spray and saturate just the adhesive. Be careful not to get the
paper to wet as it has a tendency to separate and stick to the graphic. If this
happens finish removing liner and spray your water solution to the parts that
have stuck to rinse them away.
7. Grab hold of the graphic at the far left and right bottom edge and flip it print
side out facing you and slide into position. It will fit just center of the vent
opening overlapping its edge slightly and just about 1/16” from the far edge
of the door. If your graphic seams to get stuck simply lift and spray more
solution so that it is wet and slippery enough to allow you to slide it into
position. Once you are satisfied with its position set the graphic using the
squeegee (provided) by sliding the squeegee from left to right at the very
center of the graphic, down the entire length of the graphic. Then from the
center upwards and downwards until all the water solution has been
squeezed out. Making sure not to leave any water or air pockets as you go. If
an air or water pocket does become trapped you can release it by poking a
pinhole with your snap knife and pressing the bubbles flat towards the hole.
8. Once you have successfully completed mounting your new graphic trim off
the excess graphic from the vent edge and door gap by sliding your sharp
snap knife down the edge of the car being careful not to mar the paint.
If any questions occur during installation please contact American Car Craft at 727
861-1500.