American Car Craft Corvette Plenum Cover Perforated 2005-2013 C6+GS+Z06 User Manual
American Car Craft For the car

AMERICAN CAR CRAFT INSTRUCTIONS
C6 PERFORATED PLENUM COVER
PART#043025
patent pending
PARTS INCLUDED:
1-Stainless Plenum Cover
2-Strips of Velcro Attachment Tape
1-Pack of adhesive Promoter
1-Test Kit
Your new cover comes to you with a protective liner. Remove liner after installation
is complete.
1. Surface Preparation: Your new cover is designed to attach to your existing
stock fuel rail covers via Velcro tape. PLEASE NOTE: If silicone treatments
have previously been applied to your fuel rail covers please refer to the
special preparation instructions attached. If silicone treatments have not
been applied then continue by first removing all road dirt and grime with
soap and water. Then scrub your fuel rail covers along the entire most inner
corner with household isopropyl alcohol. (This is where your new plenum
cover will sit). Let dry then wipe same area with the adhesive promoter
(provided).
2. Your new cover has 2 Velcro strips of attachment tape on its underside.
Remove the hook side from both strips and set aside for a moment. Place
your new cover on top of the factory fuel rail covers and line up so that it
appears nice and straight and flush with the back gasket ridge.
3. The next step is to place a length of masking tape on either side of the new
plenum cover directly onto both factory fuel rail covers. Doing this will
indicate where the new cover sits.