American Car Craft Hummer H2 Door Guards Brushed Front & Rear 4Pc 2003-2007 - Manual (Page 2)

1. BEFORE YOU BEGIN YOU MUST FIRST PREP THE DOOR PANEL IN
ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the
entire area first with household isopropyl alcohol. Then closely follow the
procedures outlined in the following steps!!!!
2. If your door panels have been treated with armor-all or silicone
coatings, installation will NOT work unless these treatments have
been REMOVED with special chemicals! Household Isopropyl
alcohol alone WILL NOT remove it. NOTE: Some doors have been
treated at the dealerships and the factory before you purchased the
car. So to be extra safe we suggest that you please refer to the
SPECIAL PREPARATION INSTRUCTIONS enclosed. We can not be
responsible for panels’ not sticking due to improper door
preparation!
3. NOTE: YOU HAVE BEEN PROVIDED WITH 1 (or 2) SMALL
ABRASIVE PADS AND 2 (or 4) TEST STRIPS ONE FOR EACH DOOR.
4. Apply a strip of masking tape along the door panel above the contour to
protect it. Lightly scuff the door panel along the entire perimeter to be
mounted and wipe off any and all shavings. This step will produce a raw
surface. Once this is done swipe the entire perimeter with the adhesive
promoter (provided). Allow a few seconds to dry. Use one of the test
strips provided to test tackiness of the door panel area to be mounted. If
all the procedures from the SPECIAL PREPARATION INSTRUCTIONS
have been preformed properly your test strip will stick. If it does not stick
perform the entire preparation again until it does.
DON’T ATTEMPT TO
INSTALL YOUR DOOR GUARDS UNTIL YOUR TEST STRIPS ADHERE
PROPERLY.
Installation errors are NOT manufacturing defects and parts CANNOT be
returned due to improper installation.
5. Before you remove the red liner for permanent attachment place the door
guard into position and check the fit. Please refer to the pictures at the
end of these instructions. Make note of its position.
6. Remove the red liner (be sure not to touch the adhesive) and carefully
reposition the door guard, press firmly on the panel to set.
7. Once your panel has been properly installed remove the protective liner.
You have been provided with a length of chrome trim. This trim is
designed to cap the front two door guards for a nice finished look. Using