American Car Craft Camaro Fuel Rail Covers Perforated "SS Style 2010-2012" - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
DESCRIPTION
Camaro Replacement Fuel Rail Covers
Camaro Plenum Cover
PART #103038 or #103037 Illuminated
PART #103035 or #103034 Illuminated
Parts Included:
4-Washer Head Style ¼ 20 Elevator Bolts
4-Small Stainless Flat Washer Spacers
4-Yellow Spacers
4-1/4 20 Clip Nuts
1-36”' Wire w/3 pigtail plugs and one 7 amp fuse holder (optional lighted version only)
Introduction: These new accessories are designed to fit the 2010-2012 Camaro LS3 engine. The accessories require you
to perform our wire tuck instructions before you attempt to install these parts. SEE BELOW
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
1. You will notice two exposed holes directly on the fuel rails. These two holes will be fitted with a special washer head
bolt and flat washer provided in your kit, your kit will have four 1/4 20 clip nuts. Place these clip nuts over the exposed
holes in the fuel rails with the nut part facing in towards the plenum. Place the new plenum cover over the two fuel rails
and line up the holes. Peel the protective liner away from the holes and the entire length of the side. Place the small
stainless flat washer over the nut hole and install the special bolt and snug down. It will not be necessary to make these
bolts very tight just snug will work fine. You have now created an attachment anchor for your new fuel rail covers. The
flat washer will provide clearance and has been added to allow the new cover to slide over the bolt head. You have been
provided with four yellow spacers. These spacers may only be used to allow you to attach the plenum cover under any
of the four holes should they be necessary. (With the fuel rails you have been provided with a second base plate section
for each fuel rail.)
2. Unplug the spark plug wire from all four coil packs. Loosen the lower bolts of all four coil packs and then place the
spark plug wires though the holes of the base plate and reattach them to the coil packs then slide the fuel rail base plate
under the loosened bolts and then retighten . The bottom of this section will rest directly on the lower ridge of the
engine.