American Car Craft Corvette Door Guards Brushed with Carbon Fiber "CORVETTE Inlay 2Pc 2005-2013 C6" - Manual (Page 2)

3. NOTE: YOU HAVE BEEN PROVIDED WITH A SMALL ABRASIVE PAD
AND 2 TEST STRIPS ONE FOR EACH DOOR.
4. Apply a strip of masking tape along the door panel above the contour to
protect it. Lightly scuff the door panel along the entire perimeter to be
mounted and wipe off any and all shavings. This step will produce a raw
surface. Once this is done swipe the entire perimeter with the adhesive
promoter (provided). Allow a few seconds to dry. Use one of the test
strips provided to test tackiness of the door panel area to be mounted. If
all the procedures from the SPECIAL PREPARATION INSTRUCTIONS
have been preformed properly your test strip will stick. If it does not stick
perform the entire preparation again until it does.
DON’T ATTEMPT TO
INSTALL YOUR DOOR GUARDS UNTIL YOUR TEST STRIPS ADHERE
PROPERLY.
Installation errors are NOT manufacturing defects and parts CANNOT be
returned due to improper installation.
Before you remove the red liner for permanent attachment place the door
guard into position and check the fit. Your panel comes to you preformed
however it will be necessary to form by hand to insure a nice perfectly
contoured fit. When you are holding the panel up to the door it
should lay flat and conform to the shape of the door without forcing
it. (In other words it should look like it is installed and not be protruding
from the door panel in any way). Please refer to the pictures at the end
of these instructions. Make note of its position. NOTE: Be sure that the
points tuck into the door panel and do not protrude. PLEASE NOTE: Metal
will not bend out of place itself so if it is properly formed and installed the
panels will remain in place.
5. Remove the red liner (be sure not to touch the adhesive) and carefully
reposition the door guard, press firmly on the panel to set.
6. Remove protective liner. Then repeat steps 1-7 for the other door.
If any questions occur during installation please contact American Car Craft @
727-861-1500.
Thank you and enjoy your purchase!