American Car Craft Corvette Door Guards Brushed with Carbon Fiber "CORVETTE Inlay 2Pc 2005-2013 C6" User Manual
American car craft instruction
AMERICAN CAR CRAFT INSTRUCTION
C6 “CORVETTE STYLE” BRUSHED STAINLESS DOOR GUARDS
PART # 041048 Patent Pending
INSTALLATION INSTRUCTIONS
Parts Included:
2-Brushed Door Guards
2-Tape Test Strips
1-Abrasive Pad
2-Adhesive Promoter Packs
YOUR DOOR GUARDS COME TO YOU WITH A PROTECTIVE LINER
DO NOT REMOVE PROTECTIVE LINER UNTIL STEP 7. NOTE: FLAME
GRAPHIC DOOR GUARDS DO NOT HAVE A PROTECTIVE LINER.
!!!!!VERY IMPORTANT!!!!!
PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING YOUR
INSTALLATION! YOU MUST FOLLOW THESE INSTRUCTIONS EXACTLY OR
YOUR NEW PANELS MAY NOT ADHERE.
1. BEFORE YOU BEGIN YOU MUST FIRST PREP THE DOOR PANEL IN
ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the
entire area first with household isopropyl alcohol. Then closely follow the
procedures outlined in the following steps!!!!
2. If your door panels have been treated with armor-all or silicone
coatings, installation will NOT work unless these treatments have
been REMOVED with special chemicals! Household Isopropyl
alcohol alone WILL NOT remove it. NOTE: Some doors have been
treated at the dealerships and the factory before you purchased the
car. So to be extra safe we suggest that you please refer to the
SPECIAL PREPARATION INSTRUCTIONS enclosed. We cannot be
responsible for panels’ not sticking due to improper door
preparation!