American Car Craft Corvette Alternator Cover Perforated 2005-2013 C6+Z06+GS - Manual (Page 2)

bracket and forward enough so that the two holes line up top dead center of
this bracket and mark the holes with a fine point marker.
3. Once you are satisfied with the location and have marked the position
remove the new cover completely. Using a center punch accurately drill into
the soft aluminum bracket using a 9/64
th
drill bit about ½” down. NOTE:
This in no way will threaten the integrity of the stock bracket.
4. Once the 2 holes have been accurately drilled you can now begin the final
installation. Partially remove the protective liner from the long tongue, just
past the mounting holes and reposition atop the alternator bracket, visually
line up the holes. Place one of the small sheet metal screws (provided) thru
one of the clear white button cover sockets (provided). Install the screw being
careful not to over tighten! A HELPFUL TIP! Once one of the screws has
been installed re-pilot the remaining hole (this will insure that the last screw
goes in nice and straight) blow off any shavings and install the last screw.
5. Snap on the 2 chrome screw covers (provided). Be sure they SNAP in place.
Remove the remainder of the protective liner.