American Car Craft Corvette Alternator Cover Perforated 2005-2013 C6+Z06+GS - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 POLISHED PERFORATED ALTERNATOR COVER
PART# 043054
patent pending
PARTS INCLUDED:
1-Stainless Alternator Cover
2-White Nylon Sockets
2-Chrome Cap Covers
2-#8 Pan Head Screws 3/8”
Your new cover comes to you with a protective liner. Do not remove liner until step 5.
1. NOTE: If you are also installing American Car Craft fuel rail covers or the
full engine shroud, you should install them first as these parts will dictate the
best position to install your new alternator cover.
2. Start by simply placing your new cover over the stock alternator and into the
engine cavity just behind the power steering reservoir; at this cavity your
new cover should rest just above the metal line there. The tongue of the
alternator cover should also slide under the large vacuum tube just to the
right of the throttle body and the wire harness should be pushed down
allowing the new cover to slide over the wire harness. (see pictures) Once in
position manipulate the new cover so that it sits squarely on the alternator