American Car Craft Corvette Fender Trim Plates 4Pc Polished 2010-2013 Grand Sport Only - Manual (Page 2)

2. Before you permanently attach your new parts begin by placing them in position to become acquainted with their
placement and to check there overall shape. Tweak the shape and practice placing them into position a couple of times
before you remove the liner. The adhesive on the parts is very aggressive and will not allow you to reposition the panels
should they make contact in the wrong position. So go slowly and sure.
3. When you are ready peel the red release liner from the back of each section and then carefully set them in place
pressing very firmly along there lengths to set the bond. Remove the protective liners to finish the installation.
4. You have been supplied with 4 precut strips of molding that if you choose can be applied to the factory paint that runs
along the edges of the stainless plates that you just installed which would cap off the edges of your new plates.
If you have any question during installation, please call American Car Craft
At 727.861.1500.
Thank you for your purchase!
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520
www.americancarcraft.com