American Car Craft Corvette Door Guards Brushed 2Pc 2005-2013 C6 - Manual (Page 2)

entire area first with household isopropyl alcohol. Then closely
follow the procedures outlined in the following steps!!!!
2. If your door panels have been treated with armor-all or silicone
coatings, installation will NOT work unless these treatments have
been REMOVED with special chemicals! Household Isopropyl
alcohol alone WILL NOT remove it. NOTE: Some doors have been
treated at the dealerships and the factory before you purchased the
car. So to be extra safe we suggest that you please refer to the
SPECIAL PREPARATION INSTRUCTIONS enclosed. We cannot be
responsible for panels’ not sticking due to improper door
preparation!
3. NOTE: YOU HAVE BEEN PROVIDED WITH A SMALL ABRASIVE PAD
AND 2 TEST STRIPS ONE FOR EACH DOOR.
4. Apply a strip of masking tape along the door panel above the contour
to protect it. Lightly scuff the door panel along the entire perimeter
to be mounted and wipe off any and all shavings. This step will
produce a raw surface. Once this is done swipe the entire perimeter
with the adhesive promoter (provided). Allow a few seconds to dry.
Use one of the test strips provided to test tackiness of the door panel
area to be mounted. If all the procedures from the SPECIAL
PREPARATION INSTRUCTIONS have been preformed properly your
test strip will stick. If it does not stick perform the entire preparation
again until it does. DON’T ATTEMPT TO INSTALL YOUR DOOR
GUARDS UNTIL YOUR TEST STRIPS ADHERE PROPERLY.
Installation errors are NOT manufacturing defects and parts CANNOT be
returned due to improper installation.
Before you remove the red liner for permanent attachment place the
door guard into position and check the fit. Your panel comes to you
preformed however it will be necessary to form by hand to insure a
nice perfectly contoured fit. When you are holding the panel up to