American Car Craft Corvette Air Tube Cover Polished Component 2008-2013 C6+Z06+GS - Manual (Page 2)

5. You will notice a small hole on each side of the larger cover towards the front of
the car. Fasten the new cover to the air tube using the two self tapping screws
provided thru the two white sockets. Be careful not to over tighten! Remove the
protective liner and snap on the two large chrome cap covers. Repeat this screw
assembly for the top two holes and fasten to the stud hole exposed earlier. Set the
two large 1” chrome caps onto the washer head screws, these will have butyl
attachment putty and work very well.
6. Remove protective liner from small section installed in step 3.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your
cover with a clean soft cloth first in order to prevent any particles from scratching it.
Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.