Dual Electronics XDMA6540 - Manual (Page 11)

11
XDMA6540 OPERATION
Display
Seek Tuning
Manual Tuning
Scan Tuning
Band
Storing and Recalling Station
Presets
Press DISP to toggle the display between the frequency and clock.
Note: when using the HDM90 HD Radio™ tuner, refer to page 12.
Press TUNE nn or TUNE ll for more than one second to seek
the next strong station.
Press TUNE nn or TUNE ll
momentarily to move radio
frequency up or down one step at a time. Press and hold to advance
quickly.
Note: Tuning options can be changed in the tuner setup menu.
Press SCAN on the remote control momentarily to preview strong
stations on the current band, pausing for five seconds at each.
Press SCAN on the remote control again to cancel.
Press BAND to select between FM1, FM2, FM3, AM1 and AM2
bands. Up to six presets can be programmed for each band.
Up to 18 FM stations and 12 AM stations can be stored in memory.
To store a station, select the desired band and station. Press and
hold the desired preset button (1-6) for more than two seconds.
When stored, the preset number will appear in the display. The
station can be recalled by pressing the corresponding preset
button.
AM/FM Tuner Operation
Setup Menu
General Menu
Menu Function Options
Clock
Enables/disables the clock to be displayed on the LCD when the XDMA6540 is powered
off using the power button.
Aux Front
Enables/disables the 3.5mm auxiliary input on the front panel.
• On: The auxiliary input is enabled. (default)
• Off: Auxiliary input mode is removed from the list of available modes.
Aux Rear
Enables/disables the RCA auxiliary input located behind the head unit.
• On: The auxiliary input is enabled. (default)
• Off: Auxiliary input mode is removed from the list of available modes.
Beep
When enabled, every button press will output a beep tone.
• On: Every button press will output a single beep tone.
• Off: Only press-and-hold button functions will output a double beep tone. (default)
Prog. Volume
Sets the XDMA6540 to power-on to the same volume level every time.
• Off: The unit will turn on at the last volume level that was set. (default)
• 1-30: Choosing a volume level will program the unit to always turn on at that volume.
Power-on
Message
Allows the "Good Morning/Afternoon/Evening" message that may be shown when the
unit is powered on.
Demo mode Enables/disables the demonstration mode for display purposes.
Set Clock
Adjusts the time for the internal clock.
• Press nn to adjust the hours.
• Press ll to adjust the minutes.