B&B Electronics USO9ML2-LS - Quick Start Guide - Manual

P#8506R2 ULINX 1&2 PORT_0712qsg
Important!
Install the CD Drivers
before Connecting the
Hardware to the PC.
1
Items Included
2
General
3
Installation
Quick Start Guide
Ulinx, USB to 1 Port Serial and
1 & 2 Port DIN Converters
USB to Serial Device
One Meter USB Cable
CD ROM with Drivers
This Quick Start Guide
INSERT THE DRIVER CD INTO YOUR CD-ROM BEFORE
PLUGGING THE HARDWARE INTO THE PC.
If you have inserted the hardware first and the Found New
Hardware Wizard launched, click cancel to exit the wizard
.
After inserting the CD, the Ulinx USB Driver Installation
wizard should launch automatically. If not, navigate to the
CD-ROM drive and run setup.exe. To find your CD-ROM
drive, double click “Computer” or “My Computer” on your
desktop, then double click on your CD-ROM drive (usually
D:).
In Windows Vista, if the following dialog appears, click “Run
setup.exe”.
When the Ulinx USB Driver Installation Wizard appears,
follow the wizard to complete the installation.
When the Ulinx USB Driver Installation Wizard is done
installing the driver, using the included USB cable plug the
USB hardware into an available USB port on the PC.
1. One USB port is required for each installed device.
The USB port can be native to the PC or it can be a
USB port from an installed USB hub to the PC.
Note: The devices work with USB 1.1 or 2.0 ports but
have a maximum USB data rate of 12Mbps.
Surrounding Air Ambient Temperature: 0 to 70° C
USB to Serial Device
One Meter USB Cable
CD ROM with Drivers
This Quick Start Guide