B&B Electronics SFP-1000LX-S-10KM-T - Datasheet - Manual (Page 4)

RoHS compliant
1310 nm Single-mode Transceiver, (15dB margin)
Small Form Pluggable (SFP), 3.3V
1.0625Gbd Fiber Channel/1.25 Gigabit Ethernet
Page 4 of 9
Version 1.0
Date: 03/31/2006 Headquarters :
12 Shyr Jiann Road, Hsinchu Industrial Park, Hukow,
Hsinchu Hsien,, Taiwan 303
TEL: +886-3-5986799
FAX: +886-3-5986655
Website:
www.apacoe.com.tw
Block Diagram of Transceiver
POST-Amp
&
LOS Detect
LD Driver
&
Fault Sense
RRE-
AMPLIFIER
IC
LASER
DATA
DATA/
DATA
DATA/
ELECTRICAL SUBASSEMBLY
OPTICAL
SUB-
ASSEMBLIES
Photo
Diode
DUPLEX SC
RECEPTACLE
RX_LOS
TOP VIEW (Label side)
MOD_DEF
(0)
(1)
(2)
TX_DISABLE
TX_FAULT
Transmitter Section
The transmitter section consists of a 1310 nm InGaAsP laser in an eye safe optical subassembly (OSA) which mates to the fiber
cable. The laser OSA is driven by a LD driver IC which converts differential input LVPECL logic signals into an analog laser
driving current.
TX_DISABLE
The TX_DISABLE signal is high (TTL logic “1”) to turn off the laser output. The laser will turn on when TX_DISABLE is low
(TTL logic “0”).
Receiver Section
The receiver utilizes an InGaAs PIN photodiode mounted together with a trans-impedance preamplifier IC in an OSA. This OSA
is connected to a circuit providing post-amplification quantization, and optical signal detection.
Receive Loss (RX_LOS)
The RX_LOS is high (logic “1”) when there is no incoming light from the companion transceiver. This signal is normally used by
the system for the diagnostic purpose. The signal is operated in TTL level.