beautypg.com

B&B Electronics EIR408-T - Quick Start Guide User Manual

Quick start guide, Elinx gigabit ethernet switch eir408-t, Items included

background image

EIR408-T_4712qsg

Quick Start Guide

Elinx Gigabit Ethernet Switch

EIR408-T

Items Included

1

2

Hardware Installation

3

LED Chart

4

Ports

5

Installation Complete













o

Ethernet Switch

o

CD with Support Manual

o

This Quick Start Guide

o

Panel Mount Bracket

1.

Select a mounting location and install the
switch onto a piece of DIN rail or use the
included panel mount brackets for wall or
panel mounting

2.

Connect power to the switch

12 to 48 VDC

If redundancy is desired be sure to
connect two separate power supplies by
using the two DC inputs on the terminal
blocks

If only one power input is used the Fault
LED will light (this is normal)



























RJ-45 ports: The RJ-45 ports auto-sense for 10, 100 or 1000
Mbps devices connections. The auto MDI/MDIX feature
allows connections to switches, workstation and other
equipment without changing straight through or crossover
cabling. The charts below show the cable pin assignments

for straight through and crossover
cables.







LED

Description

P1

Green

Power input 1 is active

Off

Power input 1 is inactive

P2

Green

Power input 2 is active

Off

Power input 2 is inactive

Fault

Red

Power input 1 or 2 is inactive

Off

Power inputs 1 and 2 are both active,
or no power is present

Copper Port

(Upper LED)

Green

Connected to network

Flashing

Networking is active

Off

Not connected to network

Copper Port
(Lower LED)

Green

Connected to network at 1000Mbps

Off

Not connected to 1000Mbps network

MDI Cable Pinout

Pin

Signal

1

Tx+

2

Tx-

3

Rx+

6

Rx-

MDI-X Cable Pinout

Pin

Signal

1

Rx+

2

Rx-

3

Tx+

6

Tx-

MDI Cable Pinout

Pin

Signal

1

Tx+

2

Tx-

3

Rx+

6

Rx-

MDI-X Cable Pinout

Pin

Signal

1

Rx+

2

Rx-

3

Tx+

6

Tx-

1. Auto MDI/MDI-x is
supported. A straight
through or cross-over
cable may be used.

2. 10/100/1000 auto
negotiation and full/half-
duplex are supported.

1. When the network cables are attached and power

is applied, installation is complete.

2. The switch will automatically discover network

devices, populate its MAC address table, and
pass traffic to the appropriate ports.