B&B Electronics EIRP410-2SFP-T - Quick Start Guide - Manual

EIRP410-2SFP-T-0912qsg
Quick Start Guide
Elinx PoE Ethernet Switch
EIRP410-2SFP-T
Items Included
1
2
3
LED Chart
Ports
Log into the Switch
5
4
o Ethernet Switch
o CD with Support Manual
o This Quick Start Guide
o Panel Mount Bracket
1. Select a mounting location and install the
switch onto a piece of DIN rail or use the
included panel mount brackets for wall or
panel mounting
2. Connect power to the switch

48 VDC
 For redundancy connect two separate power supplies
using the two DC inputs on the terminal blocks
 If only one power input is used the Fault LED will light.
LED Status Description
PWR
Green The Switch is powered on
Off The Switch is powered off
PWR1
Green Power Source 1 is available
Off Power Source 1 is unavailable
PWR2
Green Power Source 2 is available
Off Power source 2 is unavailable
Fault
Red Power or Port failure
Off Normal Operation
R.M
Green
The Switch is the master of a redundant ring
(X-Ring)
Off
The Switch is not the master of a redundant
ring.
Ports 9, 10
LNK/ACT
(SFP) Green SFP Port is linked
Blinking Data is being transmitted or received
Off Not connected to the network
FWD
P1 to P8
Green
The port is supplying power to the connected
device
Off
No device attached or no power is being
supplied
Ports
9, 10
(RJ-45)
T Green Port is linked
T Blinking Data is being transmitted or received
T Off Not connected to the network
B Green Operating at 1000M
B Off Disconnected or 10/100M
Ports
1 to 8
(PoE)
T Green Connected to the network
T Blinking Data is being transmitted or received
T Off Not connected to the network
B Yellow Operating in full-duplex
B Blinking Data collision
B Off Half-duplex or not connected
Note
Ports 1 to 8 are 10/100 PoE RJ-45, Ports 9 and 10 are
10/100/1000 RJ-45 or 100/1000 SFP.
RJ-45 ports: The RJ-45 ports auto-sense for 10 or 100 Mbps
device connections. The auto MDI/MDIX feature allows
connections to switches, workstation and other equipment
without changing straight through or crossover cabling. The
charts below show the cable pin assignments for straight
through and crossover cables.
PoE ports: The PoE ports on this switch follow Alternative A
standards and are limited to 15.4 Watts of power output per
port. Ports 1 thru 4 support the IEEE802.3af standard and
are classified as (PSE) power sourcing equipment, which
means they can be used to power (PD) powered devices.
1. Once power is applied and devices connected, the
switch will automatically discover standard and PoE
network devices.
MDI Cable Pinout
Pin Signal
1 Tx+
2 Tx-
3 Rx+
6 Rx-
MDI-X Cable Pinout
Pin Signal
1 Rx+
2 Rx-
3 Tx+
6 Tx-
Hardware Installation