B&B Electronics 856-17620--47 - Datasheet - Manual (Page 2)

International Office: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax 433-5104
European Office: Westlink Commercial Park Oranmore Co. Galway Ireland +353 91 792444 Fax +353 91 792445
[email protected]
[email protected]
10/100 mbps managed optical
demarcation compact cpE device
IE-MiniFiberLinX-II/Telco
SpecificationS
General
Preserves complete end-to-end fiber connection integrity
Bi-directional bandwidth control (per port, per direction, per VLAN)
Read/write IEEE 802.1Q VLAN-tags
Extra Tagging with Q-in-Q mode (802.1p)
Supports passive 802.3ah OAM (Operation, Administration & Management)
QoS: IEEE 802.1p-based packet prioritization (2 queues [high/low] with
8 levels of priority)
VLAN filtering up to 32 values
Layer 2 packet switching, store and forward operation
Forwarding rate: 14,881 pps for 10 Mbps; 148,810 pps for 100 Mbps
AutoCross for MDI/MDIX
Features Auto Negotiation and Selective Advertising
Supports Half and Full-Duplex operation
MTU: Supports over-sized packets up to 1916 bytes per packet
Security
Password Control
Multiple Access Levels: User Assigned Accounts & Access Levels
ManaGeMent
SNMP V1 and V2c compatible
Includes GUI-based iView² software for remote management and upgrades
Monitors far-end (remote) status without a physical presence or separate
connection
IEEE 802.3x Flow Control
Includes DHCP and TFTP clients
Supports Telnet
Includes loopback test modes (MAC swap)
Includes LinkLoss and FiberAlert
Remote capabilities with built-in support for UMA (IP-less management)
RS-232 (Craft) interface for local management
Serial cable for direct connection to a PC’s Serial Port
EthErnEt Protocols suPPortEd
EEE 802.3i 10Base-T twisted pair
IEEE 802.3u 100Base-TX twisted pair
IEEE 802.3u 100Base-FX or SX fiber
MEchanical
Dimensions
0.83”H x 1.80”W x 3.35”D
(2.11 x 4.57 x 8.51 cm)
PowEr
AC Wall Adapter: 100 to 240 VAC ±10% input, 5 VDC output, 2A max.
DC Input Voltage: 12 to 48 VDC *, 1 to .02A, 7 to 50 VDC, 1 to 0.1A
EnvironMEntal
Operating Temperature +14° to +122° F (-10° to +50° C) AC Adapter
-13° to +167° F (-25° to +75° C) DC Adapter
-49° to +185° F (-45° to +85° C) DC Telco
Storage Temperature -49° to +185° F (-45° to +85° C)
Operating Humidity 5 to 95% Non-condensing
rEgulatory aPProvals
FCC Class A
UL/cUL, CE, CSA, CB
(85,1)
3.35
(31,75)
1.25
(1.0)
.04
(26,4)
1.04
(46,0)
1.81
mEchanIcal dIagram
(dimensions in inches & millimeters)