B&B Electronics 855-10260--74 - Manual - Manual (Page 5)

2
Installing the McBasic 10/100
The McBasic 10/100 comes ready to install. The only adjustments that may need
to be made after installation are:

Configuring the mode of operation and other features on the unit.
 Setting the twisted pair port for a crossover workstation or pass-through
connection.
To install McBasic 10/100:
1. First make sure the unit is placed on a suitable flat surface, leaving some
space at the back of the unit.
2. Attach the cables between the McBasic 10/100 and each device that will be
interconnected.
3. Plug the unit into a reliable, filtered power source.
NOTE
All network cables must be connected before the link LEDs will glow.