Rainbow Electronics MAX1618 - Manual (Page 3)

MAX1618
Remote Temperature Sensor
with SMBus Serial Interface
_______________________________________________________________________________________ 3
ELECTRICAL CHARACTERISTICS (continued)
(V CC = +3.3V, configuration byte register = X8h, T A = 0°C to +85°C, unless otherwise noted.)
ELECTRICAL CHARACTERISTICS
(V CC = +3.3V, configuration byte register = X8h, T A = -55°C to +125°C, unless otherwise noted.) (Note 5)
CONDITIONS
Monotonicity guaranteed
T R = +60°C to +100°C
Bits 8 Temperature Resolution (Note 1)
-3 3
T R = -55°C to +125°C
°C
-5 5
Initial Temperature Error,
Remote Diode (Note 2)
V 3 5.5 Supply-Voltage Range
From stop bit to conversion complete
Autoconvert mode
ms 47 62 78 Conversion Time
% -25 25 Conversion-Rate Timing Error
UNITS MIN TYP MAX PARAMETER
CONDITIONS SYMBOL
ALERT forced to 5.5V µA 1
ALERT Output High
Leakage Current
ALERT forced to 0.4V mA 6 ALERT Output Low Sink Current
UNITS MIN TYP MAX PARAMETER
(Note 3) kHz DC 100 SMBus Clock Frequency
90% to 90% points t HIGH µs 4 SMBCLK Clock High Time
10% to 10% points t
LOW
µs 4.7 SMBCLK Clock Low Time
90% to 10% points t
F
ns 300 SMBCLK, SMBDATA Fall Time
90% to 90% points
10% to 90% points
t SU:STA ns 500
SMBus Repeated Start
Condition Setup Time
µs 4.7
SMBus Start Condition
Setup Time
t R µs 1 SMBCLK, SMBDATA Rise Time
pF 5
SMBCLK, SMBDATA Input
Capacitance
90% of SMBCLK to 10% of SMBDATA t SU:STO µs 4
SMBus Stop Condition
Setup Time
(Note 4)
10% of SMBDATA to 90% of SMBCLK
t
HD:DAT
µs 0 SMBus Data-Hold Time
90% of SMBDATA to 10% of SMBCLK t SU:DAT ns 250
SMBus Data Valid to SMBCLK
Rising-Edge Time
t HD:STA µs 4
SMBus Start Condition
Hold Time
Master clocking in data µs 1
SMBCLK Falling Edge to SMBus
Data-Valid Time
Between start/stop condition t BUF µs 4.7 SMBus Bus Free Time
V CC
t CONV
SYMBOL