Rainbow Electronics GM862-GPS - Manual (Page 70)

GM862-GPS Software User Guide
1vv0300729 Rev. 5 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 70 of 120
3.5.3 Writing a New SMS to storage
A new SMS can be written in the selected storage (in the current SW version only "SM" is
supported) and then can be sent to the desired destination.
To write the new SMS:
•
send command AT+CMGW=""
where:
: destination address
•
wait for prompt " > "
•
send SMS text (MAX 160 characters)
•
end command with CTRL-Z character (0x1A hexadecimal) or abort command with ESC character
(0x1B hexadecimal)
•
wait for response:
Response Reason Action
+CMGW:
OK Message has been successfully
written in position number
proceed ahead
ERROR some error occurred Enable the extended error
codes report (see par.2.5.2.1)
and retry.
+CMS ERROR: 330 SMSC address unknown Insert SMSC address (see par.
3.5.1.3)
+CMS ERROR: 322 Memory Full memory is full, hence delete
some records and retry.
NOTE: if command is aborted with ESC character, then only the OK result code is returned.