Rainbow Electronics GM862-GPS - Manual (Page 42)

GM862-GPS Software User Guide
1vv0300729 Rev. 5 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 42 of 120
3.2.1.1 Set the extended incoming call indication
•
Send command AT+CRC=
where:
is the operation mode selected:
0 – extended results Disabled (device reports RING only)
1 – extended results Enabled (device reports +CRING: indication)
•
wait for
OK
response
3.2.2 Identify the Caller
The GM862-GPS is able to identify the caller number and give indication of it before the call is
answered.
The calling number is presented after each RING or +CRING indication in the format:
+CLIP: "",[,"",[,""[,]]]
OK
where:
is the phone number;
is the type of number:
145 – international numbering scheme
129 – national numbering scheme
is the subaddress of the calling party
is the type of subaddress
is an optional string type alphanumeric representation of corresponding to
the entry found in phonebook;
is the validity status of CLI presentation:
0 CLI valid.
1 CLI has been withheld by the originator.
2 CLI is not available due to interworking problems or limitation or originating
network.
In order to use this feature you must enable the caller ID indication presentation, if feature is disabled
then no CLI indication is given after the RING or +CRING code.