Rainbow Electronics DS92LV010A - Manual (Page 7)

Test Circuits and Timing Waveforms
(Continued)
Typical Bus Application Configurations
Application Information
There are a few common practices which should be implied
when designing PCB for BLVDS signaling. Recommended
practices are:
• Use at least 4 layer PCB board (BLVDS signals, ground,
power and TTL signals).
• Keep drivers and receivers as close to the (BLVDS port
side) connector as possible.
DS100052-10
FIGURE 8. Receiver TRI-STATE Delay Test Circuit
DS100052-11
FIGURE 9. Receiver TRI-STATE Delay Waveforms TRI-STATE Delay Waveforms
DS100052-12
Bi-Directional Half-Duplex Point-to-Point Applications
DS100052-13
Multi-Point Bus Applications
www.national.com 7