RocketFish RF-TVMFM03 - User Manual - Manual (Page 12)

12 Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
RF-TVMFM03V2 TV Wall Mount
Step 6 Install the wall plate to a wood stud wall
Note: Drywall covering the wall must not exceed 5/8" (16 mm).
1 Locate the studs. Verify the centers of the studs with an edge-to-edge stud finder and mark the centers.
2 Vertically center the wall plate template (F) at the wall height you determined in the previous step, then
align the wall plate template (F) against the wall and make sure that it is level. Tape the wall plate template
(F) to the wall, then use a pencil to mark the lag bolt hole locations (4) on the stud centers. Remove the wall
plate template (F).
Note: Your TV shifts left or right 7" (17.8 cm) from the home position to full extension.
3 Drill pilot holes to a depth of 3" using a 7/32" diameter drill bit.
4 Align the wall plate (E) with the pilot holes, then place the lag bolt washers (T) over the holes in the wall
plate (E). Insert the lag bolts (U) through the washers, then tighten the lag bolts with the socket wrench only
until the washers (T) are firm against the wall plate.
CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (U).
You’ll need
16"
40.6 cm
Center pencil mark made in
Step 5.
Wall Home
position
Full
extension
9.7 in. (24.7 cm)
7 in. (17.8 cm)
Top Dessus Parte superior Top Dessus Parte superior
RF-TVMFM03V2 Template • Gabarit • Plantilla
Note: For wood frame installations, use a stud
finder to locate wood studs first.
Remarque : Pour une construction à ossature
de bois, localiser d'abord les montants en bois,
à l'aide d'un détecteur de montants.
Nota: para la instalación en construcciones de
armazón de madera, primero debe localizar las
vigas de madera con un localizador de vigas.
Need help deciding how high to mount your TV? Scan this QR code.
Besoin d'aide pour déterminer la hauteur de montage du téléviseur? Numériser ce code QR.
¿Necesita ayuda para determinar la altura de montaje de su televisor? Escanee este código QR.
V2 13-0191
Tools Needed Outils nécessaires Herramientas requeridas
T (4)
Stud finder
U (4)
Pencil
Drill
7/32" wood drill bit
1/2" socket
wrench
Level
Tape
Wall plate (E)
Template (F)
Note: Minimum wood stud
size: Common 2 x 4 in.
(51 x 102 mm).
Nominal 1.5 x 3.5 in.
(38 x 89 mm)
RF-TVMFM03V2_13-0601_MAN_V3_ENG - GIF.fm Page 12 Tuesday, July 9, 2013 10:25 AM